Перевод описания на русский язык. CONSTRUCTION The sweater is worked in the round from the bottom up. The body is divided at the armholes for front and back yoke and each section is worked back and forth and finished separately. Each section ends with rib and short rows to shape the shoulders. The shoulder stitches are knitted together using the 3-needle bind off technique and then stitches are picked up and knitted for the sleeves along the armholes. The sleeves are worked in the round and finished with decreases in the pattern. The design has rib edges at the hem and cuffs. An Italian bind off and cast on is used. SIZE S (M) L (XL) XXL - XXXL MATERIALS 400 (400) 450 (500) 500 g Isager Eco Baby in color E7s 150 (150) 175 (175) 175 g Isager Silk Mohair in color 6 Alternative Isager Jensen Yarn: 400 (450) 450 (500) 500 g Isager Alpaca 1: 150 (150) 150 (200) 200 g MEASUREMENTS Half chest circumference: 56 (56) 63 (70) 77,5 cm 22 (22) 24¾ (27½) 30½ inches Half circumference at hem: 47 (47) 53 (59) 65 cm 18½ (18½) 20¾ (23¼) 25½ inches Body length: 29 (31) 29 (31) 29 cm 11½ (12¼) 11½ (12¼) 11½ inches Total length: 53 (55) 56,5 (59) 61 cm 20¾ (21¾) 22¼ (23¼) 24 inches Armhole length: 21 (21) 25 (25) 29 cm 8¼ (8¼) 9¾ (9¾) 11½ inches Half neck width: 20 (20) 20 (22) 22 cm 7¾ (7¾) 7¾ (8¾) 8¾ inches Sleeve length: 42 (43) 40 (38) 35 cm 16½ (17) 15¾ (15) 13¾ inches ABOUT SIZES Note the large jump between the sizes. This is because the shape follows the pattern repeat, which runs across 12 stitches. This creates a larger jump between sizes than you would have on a stockinette stitch design, for example. It’s a good idea to compare the measurements of this sweater to a sweater you have, which you like the fit of, before choosing which size to knit. The measurements given above are for the finished sweater, not body measurements. GAUGE In pattern on a 6 mm US10 needle (Note: If the design is worked in Isager Jensen Yarn/Alpaca 1, work on a 5 mm US8 needle to achieve the correct gauge): 10 cm 4 inches = 17 sts 10 cm 4 inches = 28 rows Rib (k1, p1) on a 6 mm US10 needle: 10 cm 4 inches = 18 sts 10 cm 4 inches = 26 rows NEEDLES 6 mm US10 and 5.5 mm US9 for casting on (Note: If the design is worked in Isager Jensen Yarn/Alpaca 1, use 5 mm US8 and 4.5 mm US7 for casting on)
